Rock Auto has a sale - close out going on the Walker 31369 gaskets.
These fit the collector flange on Hooker Long Tube Headers.

1.81 each

https://www.rockauto.com/en/partsearch/?partnum=31369

_________________
Doo Ron Ron and the Duke of Earl are friends of mine.....
https://www.youtube.com/watch?v=uX8Nj8ABEI8

Thank you for sharing that John.

_________________
Official Cookie and Mater Tormentor.

Just ordered enough to last me until I die.

Thanks again for posting John!

_________________
Official Cookie and Mater Tormentor.

you are welcome,, yea, I have five sets,,,

_________________
Doo Ron Ron and the Duke of Earl are friends of mine.....
https://www.youtube.com/watch?v=uX8Nj8ABEI8

Me too!

_________________
Official Cookie and Mater Tormentor.

Hi John,

Do they really have the stainless fire ring, like in your pic? The Rockauto pic has no fire ring, but maybe it is just a stock pic.

Thanks much,

Lou

_________________
Home of Slant6-powered fun machines since 1988

The pile of gaskets on the left in the photo that I posted are the gaskets from RA. The packaging says ‘Replace Walker...’
The single gasket on the right is a Walker gasket.
Both sets have a stainless ring at the center.

You are correct that the photo in the listing does not show a ring, but the ring is present on the gaskets that I got.

_________________
Doo Ron Ron and the Duke of Earl are friends of mine.....
https://www.youtube.com/watch?v=uX8Nj8ABEI8

Ordered. I'm pretty sure the Spitfire headers on my V8 Dart use the same ones.

_________________
Rob

I’m Mater
The Kentucky Poser

Great! I ordered some.

Lou

_________________
Home of Slant6-powered fun machines since 1988

Hello, Don't yell at me a lot,,,
these Rock Auto collector gaskets have an undersized bolt hole diameter that splays the collector mounting bolts and causes interference when bolting the collector to a collector extension. At least that is what I found. It is easily correctable. The RA collector gaskets have slightly under sisized ( and out of position ) mounting holes. See the overlay photo.
Use a drill bit to bring the RA gasket mounting holes to the diameter of the Walker gasket mounting holes and all is fine.

Maybe that is why the RA collector gaskets are discounted. I really don't know, but they have the stainless ID gasket and a very substantial exterior gasket, with the mounting holes small and off location.

_________________
Doo Ron Ron and the Duke of Earl are friends of mine.....
https://www.youtube.com/watch?v=uX8Nj8ABEI8

.438 vs .368 is the bolt hole diameter.

.070 undersized and not on the same nominal, see how the bolt hole centers do not align.
that will cause difficulty went assembling the header-collector gasket-collector extension.
however it is easily resolved by opening the gasket bolt hole diameter.


2.47 vs 2.48 is the center exhaust diameter
.01 difference, very inconsequential.

open the mounting bolt holes and life will be great.

_________________
Doo Ron Ron and the Duke of Earl are friends of mine.....
https://www.youtube.com/watch?v=uX8Nj8ABEI8

Mine just arrived. I might find something they will fit on.

_________________
Rob

I’m Mater
The Kentucky Poser

The bolt spread looks to be good for my Cliffords. They'll be fine.

_________________
Official Cookie and Mater Tormentor.

Thanks for the head(er)s up. No worries. I have a little pile now too.

Lou

_________________
Home of Slant6-powered fun machines since 1988